I'm having some trouble with editart. As near as I can tell it's resolution related. Part of the problem is I guess I dont' understand precisely how Jonof's port works. When I start editart, I get the normal thank you message, but then I just get a black screen. But I can still hit ESC, Y, and it will exit, so I assume everything's working, I just can't SEE it working.
Should I use the bsetup to change the resolution or is there something else I need to do? Build and Jonof's port works fine for me, just editart is the problem.
Thanks,
Mathius
Quakis at
Im not sure if dats are needed or not, but check to see if .dat files are in your directory like lookup, tables and palette etc. Or try having the doswg or however its called in your directory too, I remember one of these fixed my display at some point.
ProAsm at
This is my Editart folder although some are probably not necessary:
EDITART.EXE
PALETTE.DAT
SETUP.DAT
TABLES.DAT
TILES000.ART
TILES001.ART
TILES002.ART
TILES003.ART
TILES004.ART
TILES005.ART
TILES006.ART
TILES007.ART
TILES008.ART
TILES009.ART
TILES010.ART
TILES011.ART
TILES012.ART
TILES013.ART
TILES014.ART
TILES015.ART
TILES016.ART
TILES017.ART
TILES018.ART
TILES019.ART
TILES020.ART
TILES021.ART
Mathius at
Hrm. I have all that (except I only have 19 tiles). I can't seem to figure it out. It works fine in my old Dos duke3d directory, but the directory where I have the atomic edition of JonoF's port, it won't run properly.